Ditch-witch RT80 Bedienungsanleitung Seite 172
- Seite / 203
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
RT80Q Operator’s Manual Service - 171
As Needed
Charge Battery
Before You Start
Electronic components can be easily damaged by electrical surges. Jump starting can damage electronics
and electrical systems, and is not recommended. Try to charge the battery instead. Use quality large
diameter booster cables capable of carrying high currents (400 amps or more). Cheap cables may not
allow enough current flow to charge a dead/discharged battery.
Read all steps thoroughly and review illustration before performing procedure.
Explosion possible. Serious injury or equipment damage could occur.
Follow directions carefully.
To help avoid injury:
• Use a single 12V maximum source for charging. Do not connect to rapid chargers or dual batteries.
• Use caution and wear personal protective equipment such as safety eyewear, when charging or
cleaning battery.
• Keep sparks, flames, and any ignition source away from batteries at all times. Internal contents are
extremely hazardous. Leaking fluid is corrosive. Battery may be explosive at higher temperatures.
• NEVER lean over battery when making connections.
• Do not allow vehicles to touch when charging.
• Do not attempt to charge a battery that is leaking, bulging, heavily corroded, frozen, or otherwise
damaged.
• NEVER short-circuit battery terminals for any reason or strike battery posts or cable terminals.
• Refer to MSDS for additional information regarding this battery.
IMPORTANT: Some equipment may have a positive booster cable terminal located externally. If so
equipped, use this terminal instead of connecting directly to battery.
- Operator’s 1
- Overview 2
- Serial Number Location 3
- Intended Use 4
- Equipment Modification 4
- Unit Components 5
- Operator Orientation 6
- About This Manual 6
- Foreword 8
- Operator’s Manual 9
- Contents 10
- Guidelines 13
- Emergency Procedures 14
- If a Gas Line is Damaged 16
- If Machine Catches on Fire 17
- Safety Alert Classifications 18
- Machine Safety Alerts 19
- Attachment Safety Alerts 21
- H832 25
- Controls 30
- Center Console 31
- Graphic Display 35
- Main Menu 38
- Back Save Reset 40
- Diagnostics 42
- Right Console 44
- Seat Console 47
- Seat Deck 50
- Trencher Controls 51
- Plow Controls 52
- Combo Controls 54
- Saw Controls 56
- Backhoe Console 57
- Drill Controls 62
- Battery Disconnect 63
- Operation Overview 64
- Planning 65
- Digging with Backhoe 66
- Drilling 66
- Leaving Jobsite 66
- Gather Information 69
- Inspect Site 70
- Classify Jobsite 71
- Apply Precautions 72
- Supplies 73
- Fluid Levels 73
- Condition and Function 73
- Accessories 73
- Start Unit 75
- Drive 77
- Safe Slope Operation 78
- Shut Down 79
- Transport 80
- Lift 81
- Tie Down 84
- Haul 87
- Load 88
- Position Tractor 100
- Attach Product 100
- RT80Q Operator’s Manual 101
- Operation 102
- Start Plowing 103
- Finish Plowing 103
- Special Plowing 104
- Reel Carrier 106
- Adjust Reel Winder 107
- Chapter Contents 110
- Setup 111
- Normal Use 113
- Drilling Attachment 119
- Prepare Jobsite and Equipment 120
- Drill Pipe and Equipment 121
- Using Drill String Guide 122
- Backream 123
- Disassemble Joints 124
- Systems and Equipment 126
- Cruise Control 127
- Trenching 128
- Chain, Teeth, and Sprockets 129
- Chain Selection 130
- Optional Equipment 131
- Counterweighting 132
- Complete the Job 134
- Restore Jobsite 135
- Rinse Equipment 135
- Stow Tools 135
- Service Precautions 137
- Lubrication Overview 138
- Approved Fuel 140
- Approved Coolant 141
- Check Air Filter 144
- Check Coolant Level 144
- Check Hydraulic Hoses 146
- Trencher 147
- Lube Trencher Auger Bearings 148
- Lube Trencher Auger Shaft 148
- Check Trencher Auger Bolts 148
- Check Boom Mounting Bolts 150
- Check Restraint Bar Position 150
- Check Plow Connector Pivots 152
- 100 Hour 155
- Check Track Tension 156
- Check Track Hub Bolts 156
- Test Plow Connector Pivots 158
- 250 Hour 159
- Lube Driveshaft U-joints 160
- Lube Axle Spindle Pins 160
- 500 Hour 162
- 1000 Hour 166
- 2000 Hour 168
- As Needed 169
- Check Radiator/Oil Cooler 170
- Inspect Seat Belt 170
- Charge Battery 172
- Time Augers 176
- Check Plow Blade Bolts 178
- Replace Pins and Bushings 178
- Specifications 180
- RT80Q Tractor 182
- H810 Trencher 184
- H813 Trencher 186
- H832 Plow 188
- H853 Combo 190
- A820 Backhoe 194
- RC80 Reel Carrier 196
- Procedure 198
- Resources 198
- Warranty 199
- Service Record 202
Verwandte Produkte und Handbücher für Spezialmaschinen Ditch-witch RT80
(193 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.189 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern